Comtrend Corporation CT-5364A Manual de usuario descargar pdf (Pagina 10)

SIDE PANEL

The figure below shows the right-side panel of the device.

WPS BUTTON

Press this button to begin searching for WPS clients. These clients must also enable

WPS push button mode. When WPS is available the WPS LED will be ON.

Reset Button

Restore the default parameters of the device by pressing the Reset button for 5 to

10 seconds. After the device has rebooted successfully, the front panel should

display as expected (see section 2.2 LED Indicators

for details).

NOTE: If pressed down for more than 20 seconds, the CT-5364A will go into a

firmware update state (CFE boot mode). The firmware can then be

updated using an Internet browser pointed to the default IP address.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 122 123

Sin comentarios

Comtrend Corporation CT-5364A Manual de usuario Pagina 10